Water Treatment Division
Ten-year experience allows ASCO’s technicians to support designers, consultants and operators in the evaluation of the best application solutions for both new plants and revamping projects.
Addressing the world of primary water treatment and waste water, ASCO POMPE intends to meet the needs of all the players in the sector, from the General Contractor to the Manager, guaranteeing a targeted and personalized service aimed at improving the efficiency of their systems.
Aeration Systems
The Aquastrip panels are membrane-type fine bubble air diffusers for aeration processes of activated sludge treatment plants. The panel diffusers are large surface units fixed directly on the bottom of the tank, consisting of a support frame in AISI 316Ti or PVC, on which a 0.6 mm thick polyurethane (PU) membrane is stretched and microperforated with…
- Flowrate: 600 Nm3/h
- Temperature: 35°C
- Pressure Max: 110 mbar
IFAS
The IFAS processes, which stands for Integrated Fixed-film Activated Sludge System, are an evolution of MBBR systems. These are reactors in which biological processes are active with the coexistence of suspended biomass attached to the supports. ASCO Pompe solution provides that the adhered fraction is free to grow on the fixed …
- Specific Surface Area: 22 m2/m2
- Feed Capacity: 0,05 kgSS/m2
Turbo Blowers
APG-Neuros® Centrifugal Air Compressors are the most advanced and efficient on the market today. Result of the most advanced technologies in the aeronautical sector, they are made of air-sheet bearings and permanent magnet synchronous motors to achieve maximum energy efficiency, with savings of up to 40% compared to traditional lobe…
- Pressure: 32.000 Nm3/h
- dP max: 1 bar
Measurement of Solids
Asco Pompe offers a range of instruments for measuring the concentration of solids on wastewater treatment plants. The proposed instruments can be used for different purposes such as the measurement of solids in the recirculation, primary sedimenters output or setters inlet / outlet monitoring. Combined with each other and managed by a software …
- Concentration: 40%
- Temperature: from -20 to +70°C
Polymer Preparation Unit
Polyelectrolytes are organic substances normally used as water solutions to remove particles (by coagulation and flocculation process) in both municipal and industrial water treatment plants. The Automatic Polyelectrolyte Preparation Units are designed and manufactured to automatically prepare polyelectrolyte solutions at a required concentration, in order to optimize the consumption of polyelectrolyte
- Portata Max: 6.000 l/h
- Temp. Max: 0 °C / 60°C
- Pressione Max: 3,5 barg
Single Screw
Progressive cavity pumps are rotary volumetric pumps with eccentric screw. Self-priming, for both clean and dirty, viscous, abrasive fluids. Flow proportional to the number of revolutions and independent of pressure (viscous fluids).
Cast iron, AISI 316, Duplex st. steel, PE bodies. Rotors in carbon steel, AISI 316, AISI 410, AISI 304, Hastelloy, Duplex st. steel. Stators …
- Flowrate: Fino a 420 m3/h
- Viscosity: 48 barg
- Temperature: from -10 to 100°C
- Pressure: 1.000.000 cPs
Dosing pumps
The dosing pumps are volumetric alternative pumps with variable flow, suitable for injecting liquids with precision, linearity and repeatability. The variety of materials, the construction accuracy and the extreme modularity of the electronic component make these pumps suitable for any flow and type of liquid. Many years of experience in addition…
- Flowrate: 70 m3/h
- Viscosity: 1000 barg
- Temperature: 180°C
- Pressure: 20.000 cPs